RCA VR678HF

18
Using the Remote Control
Controlling a VCR
The VCR’s remote controls two compatible RCA, ProScan, or GE VCRs with
the VCR1 and VCR2•LD buttons. Most compatible VCRs automatically
respond to VCR1 without being programmed. If you own two compatible
VCRs, test them to see if VCR1 turns on both VCRs. If it does, then you may
want to program this VCR to respond to the VCR2•LD button on the remote.
Important Reminder: Remember you must
press VCR1 or VCR2•LD on the remote —
whichever you selected in the menu —
before the remote will operate this VCR.
Program the VCR for Remote Control
Set the Remote Control feature of the VCR
to the VCR1 or VCR2 position. The
remote then controls the VCR with either
the VCR1 or VCR2•LD button —
whichever position you select in the
menu.
1. Press MENU•PROG to display the
VCR MAIN MENU.
2. Press 6 to display PREFERENCES.
3. Press 1 to activate the Remote Control
feature.
4. Press VCR1 or VCR2•LD to change
the setting and program this VCR to
respond to the VCR1 or VCR2•LD
button — whichever you select.
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
4 Channels
5 Setup
6 Preferences
PREFERENCES
1 Remote Control: VCR2
2 Auto Play: ON
3 Auto TV/VCR: ON
4 Panel Display: AUTO
5 CF Marking: ON
6 CF Playback: AUTO
7 CF Display: BLUE
8 Set Auto Repeat
0 Exit
PREFERENCES
1 Remote Control: VCR1
PREFERENCES
1 Remote Control: VCR1
2 Auto Play: ON
3 Auto TV/VCR: ON
4 Panel Display: AUTO
5 CF Marking: ON
6 CF Playback: AUTO
7 CF Display: BLUE
8 Set Auto Repeat
Press VCR2 to change