RCB R10X - Function Description: Charging and Starting; Charge Your Scooter; Assembly Step 2: Install Handlebar

2. Install the handle bar on the stem (see image 4), and tighten the four M5
screws by the M3 Hexagon Wrench (see image 5)
(Image 1) (Image 2) (Image 3)
*NBHF*NBHF
4
5. FUNCTION DESCRIPTION
1. Charge your scooter
Please make sure that the scooter has sufficient power before each use.
The scooter is fully charged when the LED on the charger changes from red to green.