Need help?Do you have a question about the RCF ART 912-A and is the answer not in the manual?
General| Woofer | 12" |
|---|---|
| Horizontal coverage angle | 90° |
| Vertical coverage angle | 60° |
| Input signal | Balanced/Unbalanced |
| Output connectors | XLR |
| Crossover frequencies | 1.8 kHz |
| Limiter | Yes |
| High frequencies power (Peak) | 700 W |
| Cooling | Convection |
| Power connector | PowerCon |
| Cabinet Material | Plywood |
| Pole Mount/Cap | Yes |
| Color | Black |
| Width | 380 mm |
| Type | Active |
| Frequency Response | 50 Hz - 20 kHz |
| Tweeter | 1" |
| Input connectors | XLR |
| Input sensitivity | 0 dBu |
| Protections | Thermal, RMS |
| Controls | Volume, EQ |
| Hardware | M10 fly points |
Instructions for safe mains voltage connection and usage, including earthing and cable protection.
Warns about risks of high sound levels and recommends protective measures.
Advice on placement, heat, and cleaning to ensure longevity and performance.
Details the preset selector, LEDs for signal/overload, and input/output connectors.
Crucial warnings against using handles for rigging and ensuring correct pole-mount configurations.
Checks for power connection and switch status when the speaker fails to power up.
Troubleshooting steps for no sound, low volume, hissing, or distorted audio.
To Next Page
