REAR PANEL
1. BALANCED XLR INPUTS
Balanced audio inputs (for each channel) with XLR connectors.
When unbalanced signals are used, pins 1 (gnd) and pins 3 are to be connected together; use
[pins 2] for the signals.
In MONO and BRIDGE modes, use the input CH1 only.
2. BALANCED 1/4” (6.3mm) JACK INPUT
Balanced audio inputs (for each channel) with stereo jack connectors.
Use mono jack connectors for unbalanced signals.
In MONO and BRIDGE modes, use the input CH1 only.
3. SPEAKON CONNECTOR - CH1output
Amplified signal output to CH 1 loudspeakers in STEREO and MONO modes; to be used (as single
output) in BRIDGE mode.
4. SPEAKON CONNECTOR - CH2 output
Amplified signal output to CH 2 loudspeakers in STEREO and MONO modes
(note: in MONO mode, CH2 output is driven by CH1 input).
5. POWER SUPPLY SOCKET
Socket to connect the power supply cable (provided).
6. FUSE HOLDER
Housing for the mains fuse.
Note: When replacing the fuse, always use the type suitable for the mains voltage
(value shown on the rear panel).
7. MODE SWITCH
Three-way switch to change the mode among STEREO, MONO and BRIDGE.
8. AIR INTAKE GRILLE
This grille allows amplifier cooling. Do not obstruct its access and clean it when necessary.
To Next Page
Loading...
Need help?
General
