To Next Page

To Previous Page

EPSILON ES2,ES4

1-9600bps

2-19200bps

3-38400bps

4 -57600bps

At$baud=1,2

2. Set the data reading from the FLS

At$fuel=<Option>, <Time>,< Frequency >, <Temperature in degrees of centigrade>,<Level>

<Option> 0-prohibited, 1- allowed

<Time> Minimal time in seconds in the range of 1...65535 sec.

<Frequency>, < Temperature in degrees of centigrade>,<Level> -fuel data, fuel volume range

of 0...1024

Example: At$fuel=1,60 –to set data reading from FLS every 60 seconds.

Fuel data comes in a standard protocol Intellitrac A1 according to the settings, as additional 6

bytes

Using the "IntelliTrac A1" with one FLS it is necessary during sensor’s configuration to set the

text format of the data.

Using the "IntelliTrac A1" with the concentrators of sensors "DALCON" (see Appendix 4) you

have to install a text format of the data during the configuration of DALCON (see Picture A4.6).

You must also coordinate the exchange speed on the serial port in one of the ways:

-either set in the sensor exchange speed equal to the exchange speed in "IntelliTrac A1" (see

Picture A4.3)

-or set it in "IntelliTrac A1" by command AT$BAUD with a parameter equal to exchange speed

in the sensor or in DALCON.

To enable transfer of data about the level of fuel in "IntelliTrac A1", use the command

AT$FUEL.

RCS EPSILON ES4 User Manual

Questions and Answers: