Temporary user setting
The setup of the temporary user will be done after complete above 6 steps strictly.
1. Enter the menu by master’s fingerprint / password.
2. Select “Temporary User” in the “System Setting” menu.
3. Select “Add Temp. User” and input password for the temporary user.
4. Return to “Temporary User” menu, and then select “Date Setting” to set the start date and end date
that allow the temporary user to unlock by password.
(Noted: the start date and the end date cannot be set on the same day. e.g. if you want the temporary
user to unlock by password on Feb. 20th only, you should set the start date on Feb.
20th and end date on Feb. 21st. The temporary user will not be able to unlock the door by password as
of 00:00 a.m., Feb. 21st.)
5. Return to “Temporary User” menu, and then select “Time Range 1” to set the start time and end time
that allow the temporary user to unlock by password. There are 3 time ranges and at least one of them
should be set for the temporary user’s password to take effect. If you set all of the time ranges with
different time period, the temporary user can unlock by password at all set time ranges on each day of
set date.
The format of the time range is 00:00 to 23:59.
e.g. start time: 00:00
end time: 23:59
6. Return to “Temporary User” menu, and then select “Week Setting”. Follow below instruction to
complete the week setting:
A. Input number "0” or "1".
B. "0" means invalid date, "1" means valid date
C. Input 7 digits ("0" or "1" to stand for availability from Monday to Sunday. The 1st digit
stands for Monday, the 2nd digit stands for Tuesday and so on.
e.g. If the week setting is “0111110”, which means the temporary user cannot unlock the lockset on the
whole day of Monday and Sunday, but he/she can unlock the lockset at the setting time from Tuesday
to Saturday.
6
Lock operation
VIKLUND
Advanced settings
To Next Page
Loading...