Rev. A - 060220
complete.
CO2 pressure is used to force sparkling water out
of the spigot. If the CO2 cylinder is empty,
water will not flow properly. If the “Replace
CO2” light is flashing, replace the CO2 cylinder
with a new one.
No water from any
button
Ensure there is water in the 5-gallon bottle. If
the bottle is empty, replace the bottle with a new
one.
The dispenser requires power to dispense water.
Ensure the dispenser is plugged into a functional
wall outlet or power supply. LED lights will
illuminate if there is power.
Water is Leaking
From the spigot
A few drops after each dispense is normal
If water is seen continuously leaking, there may
be an issue with the dispenser. Contact your
ReadyRefresh Service Center
From elsewhere
Ensure the no-spill cover on top of the dispenser
is pushed fully down and sitting flat.
Remove the 5-gallon bottle and inspect it for
holes or damage. Place a new bottle onto the
dispenser and monitor for leaks
If leaks continue, contact your ReadyRefresh
Service Center
Water is Not
Hot/Cold/Sparkling
No Sparkling
If the CO2 cylinder is empty, water will not be
sparkling. If the “Replace CO2” light is
flashing, replace the CO2 cylinder with a new
one. If the cylinder is not empty, the cylinder
may have loosened from the cooler, causing the
gas flow to stop. Remove the cylinder and
reinstall until it is fully tight.
Water needs to be cold to properly absorb the
CO2 and provide the sparkling sensation. If the
icon is flashing, allow the dispenser to finish
chilling the water. After the icon remains
steady, the water should be fully saturated with
CO2.
Not Cold
The dispenser has two cold reservoirs to chill:
still & sparkling. Because of the large capacity,
it can take up to 2 hours to fully chill the water
after initial setup
After dispensing more than 1 liter of still or
sparkling water, the dispenser may take up to 1
hour to fully chill the water.
The dispenser needs at least 4-6” of clearance on
To Next Page
Loading...