ReadyRefresh Allure Series User Manual

Rev. A - 060220
Allure Sparkling Water Dispenser
User Manual
Warnings:
1. Misuse of the water dispenser or failure to follow directions may result in serious
personal injury.
2. DO NOT use the water dispenser if it is not in its upright position.
3. DO NOT use the water dispenser for anything other than carbonating water. Use of the
water dispenser for any unintended purposes may result in serious personal injury.
4. Use the water dispenser on a flat, stable surface away from heat sources and do not
leave in direct sunlight.
5. DO NOT place the water dispenser on a hot surface (e.g. kitchen oven/stove/ hob) and
never use it close to a flame.
6. DO NOT move the water dispenser during the carbonation process.
7. To reduce the risk of personal injury or property damage, any servicing or repair
should be performed by a ReadyRefresh authorized service representative.
8. ONLY dispense sparkling water into vessels approved for carbonated beverages.
Sealed containers may burst if not rated for pressurized use.
9. Close adult supervision is necessary when the water dispenser is used by children and
it is not recommended for use by children under 5 years of age.
I. Operating Conditions:
1. Working Voltage: AC115V±10%, 60Hz;
2. PCB Storage Temperature: -10℃～55℃; Operating Temperature: 0℃～35℃.
II. Display and Buttons:

ReadyRefresh Allure Series Specifications

General

Brand	ReadyRefresh
Model	Allure Series
Category	Dispenser
Language	English

Summary

General Safety Warnings

Operating Conditions

Display and Controls Overview

Buttons and Indicators Functions

Sparkling Water Dispense/Reset Button

Dispense sparkling water; flashing light signals reset requirement.

Sparkling Level Control Buttons

Decrease or increase sparkling water level via display bars.

Cooling Status Indicator

Flashes during cooling, remains steady when water is coldest.

Replace CO2 Indicator

Orange light indicates low CO2 gas, signaling the need for cylinder replacement.

Time to Clean Indicator

Illuminates when cleaning is due; pressing and holding resets the schedule.

Child Safety and Hot Water Dispense Button

Press and hold both buttons simultaneously to dispense hot water.

Cold Water Dispense Button

Press and hold this button to dispense cold water.

Setup Procedure

Initial Water Reservoir Filling

Fill reservoirs by inverting water bottle and dispensing initial water.

CO2 Cylinder Installation

Install CO2 cylinder by removing panel, inserting, and tightening until it beeps.

CO2 Cylinder Change

Removing and Installing CO2 Cylinder

Replace cylinder when indicated; remove panel, loosen, replace, and tighten.

Cleaning Instructions

Cold Tank Cleaning Procedure

Drain cold tank, fill with boiling water, scrub with sponge, rinse, and refill.

Draining Hot and Carbonation Tanks

Drain hot tank and carbonation tank using designated ports and tubes.

Troubleshooting

No Water Dispensing or Poor Flow Rate

Check for flashing SPARKLING WATER button; perform reset if required.

No or Slow Sparkling Water

Verify CO2 cylinder status; ensure it's installed and not empty.

Water is Leaking

Check no-spill cover, inspect bottle for damage, or contact service.

Water Not Hot/Cold/Sparkling

Ensure CO2, water levels, and chilling indicators are optimal.

Dispenser is Noisy

Address humming from compressor/pump or hissing from potential CO2 leaks.

Technical Appendix

Temperature Control Specifications

Details hot, cold, and sparkling water temperature ranges and control methods.

Carbonator Tank Water Level

Explains water level measurement and booster pump engagement.

Airlock Release Program

Describes the automatic program to clear airlocks in the sparkling reservoir.