PFtEPARATION Fort USE
POWEF] SOUF]CES
You can power your walki©-talkle from
any of the following three sourc©8:
• Internal. batteries
• Your vehicle's battery using the Sup-
plled 12-volt DC power cord
• A standard AC outlet (using an op.
tlonal 12-volt DC power Supply)
Installing/F]eplacing Battorlos
Your walkie-talkie uses eight AA balt©r.
leg and the two supplied dummy batter.
I®s, or ten nickel€admium batt©rloa. For
the longest operation and best porlor-
mance, we recommend alkalln® batter.
loo (Fladio Shack Cat. No. 23.662)I or
r®ohargeable nickel-cadmium ba`lorle9
(Cat, No. 23-125).
11 the BAIT (battery low) indica(or llght8,
roplac© or recharge your walklo.talkle'8
botlorlo8.
1. Flomove the battery compartment
aov®r by sliding it in the dir®ctlon, of
tho arrow. Li
Bat`ory Compartment Cover
2. F`omove and dispose of any old
non-rechargeable batteries if neces-
\i Sary. Then, install either eight fresh
non-rechargeable batteries and the
two supplied dummy batteries or ten
nickel€admium batteries.
Cautions:
• Be sure to install the batteries accord-
ing to the polarity symbols ( + and -)
marked on the batteries installation
label. Improper installation (incorrect
polarity) might damage the walkie-
talkie.
` .Always rep;ace all the batteries.
Never mix new and old batteries in the
walkie.talkie.
• Never mix rechargeabl© and non-
rechargeable batteries.
3. Pleplace the battery compartment
Cover.
To Next Page
Loading...