Really Right Stuff TQC-14 - QUICK-COLUMN TRIPODS; Loosen Platform Set Screws; Remove Platform and Weight Hook; Slide Quick-Column Up and Out

7
7
www.ReallyRightStu.com
4
2
QUICK-COLUMN TRIPODS
1. Tighten Butterfly Knob, then
use ⅛” hex key (included) to
loosen Platform set screw(s)
(do not remove).
2. Unscrew and remove Platform
and Weight Hook.
3. Rotate Butterfly Knob
counterclockwise no more
than two complete turns (do
not remove), then slide Quick-
Column up and out.
4. Place Platform atop Apex
and thread Weight Hook onto
the stud on the bottom of the
Platform. Screw the two pieces
firmly together; platform and
hook assembly will seat loosely
in the Apex.
5. Simultaneously hold Platform
in place and turn Butterfly
Knob counter-clockwise until
Platform and Weight Hook
assembly are secure.
6. Tighten Platform set screw(s).
7. Reverse steps to reinstall Quick-
Column. When sliding column
through Apex, align groove
in column with anti-twist tab
inside Apex.
Quick‑Column Tripods come with integrated Quick‑Column. Column is
removable for ground set; follow steps below.
1
1
2
3
5
4