SAFETY NET INSTALL
1. Locate safety net assemblies.
NOTE: they may be located inside of
glove box.
2. Install both latch straps to front
and rear points on roll cage.
Ensure the long strap faces the rear.
3. Remove rear floorboard Philips
screw.
4. Place safety net floor bracket on
floorboard mounting location and secure
with Phillips screw that removed earlier.
5. Pull each safety net strap until net
is secure in place.
Tools Needed:
Phillips Head Screw Driver
Strap Buckle
Long Strap
Mounting Locations
10
To Previous Page
Loading...