D
K
E
C
J
M
L
N
P
A
B
Q
R
F
G
O
I
H
K
J
M L
N P
R
F
G
O
I H
U
A
F
E
J
K
L
C
H
B
G
D
I
M
N
O
P
Q
R
1
S
S
F
S
Q
PARTS INCLUDED IN THE BOX
1x Hard fold cover
1x Driver side rail
1x Passenger side rail
1x Driver side rail extender
1x Passenger side rail extender
1x Bulkhead seal (on selected make/models)
2x Cover retainer clamps
8x Clamps
2x Buckle ends
2x Gaskets
4x Screws
4x Nutserts
6xRubberllerstrips(on selected make/models)
3x D-shaped cab bumpers
2x Rail connectors
2x Rail couplers
8x Lock washers
8x Screws
8x 2x Drain tubes
TOOLS REQUIRED
•
Scissors or utility knife
•
Isopropyl alcohol
•
1/2” Wrench or socket
•
Phillips screwdriver
•
5/8” Drill bit & drill
NOTE:
It is important that all areas where
the bed cover mounts are clean and free of
debris prior to installing.
Installing Seal: If a bulkhead seal (F) is
included with the cover (A), clean the top of
the bulkhead with soap and water to remove dirt
and debris. Clean the area with isopropyl alcohol
to remove wax or grease and to evaporate any
remaining water. Allow the surface to dry. Peel the
backing and adhere the seal from one bulkhead
edge to the other. Remove any excess with scissors
or a utility knife. Apply pressure evenly to the entire
seal to ensure proper adhesion. If the truck has a
drop-in bedliner, no seal will be needed.
RealTruck BAK Industries•1100N.GlenstoneAve.Suite140,Springeld,MO65802•818-365-9000©RealTruck Group, Inc., 2024
Part# 318S0077 Rev. 1-15-24
8’ COVERS
INSTALLATION SHEET
Any damaged or missing parts?
Parts will be shipped to you directly.
Call 818-365-9000 Mon - Fri 8:30 am - 7:00 pm EST
or email support@bakindustries.com
Need help?
General
To Next Page
