Cab
TOOLS REQUIRED
•
Scissors or utility knife
•
Isopropyl alcohol
•
1/2” Wrench or socket
•
Phillips screwdriver
•
5/8” Drill bit & drill
NOTE:
It is important that all areas where
the bed cover mounts are clean and free
of debris prior to installing.
If a bulkhead seal (F) was NOT included in your kit, skip to step 2. If you
received a bulkhead seal (F) with the cover (E), clean the top of the bulkhead
with soap and water to remove dirt and debris. Clean the area with isopropyl
alcohol to remove wax or grease and to evaporate any remaining water. Allow
the surface to dry. Peel the backing and adhere the seal from one bulkhead edge
to the other. Remove any excess with scissors or a utility knife. Apply pressure
evenly to the entire seal to ensure proper adhesion. If the truck has a drop-in
bedliner, no seal will be needed.
INTERNATIONAL
FLEX
l
ULTRA FLEX
l
ARMORFLEX
INSTALLATION SHEET
Any damaged or missing parts?
Parts will be shipped to you directly.
Call 866-900-8800 Mon - Fri 8:00 am - 5:00 pm CST
or email info@undercoverinfo.com
RealTruck UnderCover • 59 Absolute Dr., Rogersville, MO 65742 • 866-900-8800 ©RealTruck Group, Inc., 2025
Part# FX101419_Install Rev. 1-2-25
1
G H I
A
D
H
G
C
B
E
F
I
J
K
M
L
F J K
ML
PARTS INCLUDED IN THE BOX
1x Passenger side rail
1x Passenger side add-on rail
1x Driver side rail
1x Driver side add-on rail
1x Hard fold cover
1x Bulkhead seal (on select make/models)
2x Cover retainer clamps
6x Clamps for side rails
2x Buckle ends
4x Screws
6x Clamps for add-on rails
2x Drain tubes
12x Rubber ller strips
(3 sets of 3 different sizes included)
A
E
C
F
G
H
I
J
B
D
K
L
M
To Next Page
Need help?
General
