2–EN
FEATURES AND SPECIFICATIONS
12 digit capacity display with zero suppression. Single spacing after the result is printed.
Selective method of determination of decimal point placement.
1) Fixed decimal places (0, 2, 3)
2) Full oating decimal point system (F)
3) Addition mode (+)
2. Functions:
Addition, subtraction, multiplication, division. Repeated addition and subtraction, chain
multiplication and division, constant multiplication and division, mixed calculation, memory
calculation, percent calculation, Add-on / discount calculation, subtotal printing, sign change,
round- off (5/4).
3. Special features:
a) Full 12 digit capacity
b) Zero suppression
c) Automatic clear function
d) Selection of decimal point placement (+, 0, 2 ,3, F)
e) Round off control
f) Accumulation control
g) Non-print selection
“M“ Memory sign, “–“ Minus sign, “E“ Error / Overow
5. Printing colours:
All numbers are printed in blue or red. All symbols are printed only in blue.
Addition / Subtraction 12 digits ± 12 digits ≤ 12 digits
Multiplication / Division 12 digits × / ÷ 12 digits ≤ 12 digits
7. Printing speed:
2 lines per second (normal)
8. Dimensions:
58 x 154 x 219 mm
409 g
DC 6V 2.0W (UM-3 / AA BATTERY x 4) /
AC ADAPTOR D.C 6V 0.4
11. Power consumption:
2 W
12. Ambient temperature:
0°C to 40°C
How to change the ink roller
1) Switch off the calculator and open the printer cover.
2) Hold the cover of the ink roller and pull the ink roller out.
3) Insert a new roller back to the slot. Push the roller, until it locks rmly into position.
4) Close the printer cover.
• Use only the ink roller (IR-100BR).
How to change the paper roll
1) Pull out the paper roll holder.
2) Cut the paper end straight with scissors and insert the end into the printer slot.
3) Put the roll on the holder.
4) The roll dimensions should be 58 mm wide and 86 mm in diameter.
5) Insert the paper into the slot on the rear side of the calculator. Make sure that the paper is fed
from underneath the holder to the printer.
6) Switch the calculator on. Press the paper feed key until the paper end goes through
the printer as far as the paper cutter.
How to replace batteries
1) Open the battery compartment on the rear side of the calculator.
2) Remove the unloaded batteries.
3) Insert new batteries with correctly orientated battery poles.
4) Close the battery cover.
Care / Maintenance
• To prevent electrical shock, disconnect adaptor before servicing.
• Do not bend or twist the calculator.
• Avoid contact of the calculator with water or other liquid.
• Do not expose it to any strong impact, shock and vibration.
• Use a soft, dry cloth to clean the calculator.
• Do not leave a dead battery in the device. It may leak electrolyte and cause damage
to the calculator.
To Next Page
Loading...
