REC ALPHA PURE - Page 17

-
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
Rev: . US
REC Installation Manual - Module REC Alpha - IEC/IEC
Ref: PM-IM-
Rev: . US
-
INSTALLATION OF REC ALPHA PURE SERIES PANELS
Clearance Gap
. - . in
 -  mm
. - . in
 -  mm
>. in
> mm
Clamping Zone
Design Load
Test Load
Design Load
Test Load
Design Load
Test Load
Long Side
Mounting
 -  in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
 - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. -  in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
 - . in
 -  mm
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
Short Side
Mounting
 - . in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
. - . in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
MOUNTING REC ALPHA PURE SERIES PANELS WITH CONTINUOUS RAILS PARALLEL TO SHORT SIDE OF THE PANEL
A continuous rail (or other support structure) spans the complete underside of the panel
Clamping of REC Alpha Pure Series panels with Rails parallel to the Short Side of the Panel
Rail positioning
Rail positioning
NOTE
Once a module is secured in each of the  zones , additional clamps, i.e., ≥, may be freely located on panel frame without affecting the warran-
ty. Loads marked with a * were not certified as part of IEC / testing; these have been evaluated by REC’s internal testing process.
CAUTION
The center point of each clamp and the minimum grip length must be fully located in the same clamping zones to be rated to that load. If the
panel is secured in zones with diff erent load values, it is rated to the lowest load value only.
1
2
43
375 mm
700 mm
505 mm
300 mm
200 mm
0
255 mm
0
300 mm
200 mm
0
300 mm
200 mm
0
300 mm
200 mm
0
610 mm
375 mm
700 mm
505 mm
0
255 mm
610 mm
14.8 in
27.5 in
19.9 in
11.8 in
7.9 in
0
10.0 in
0
11.8 in
7.9 in
0
11.8 in
7.9 in
0
[11.8 in
7.9 in
0
24.0 in
14.8 in
27.5 in
19.9 in
0
10.0 in
24.0 in
Fig. -