REC ALPHA PURE - Page 31

-
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
Rev: . US
REC Installation Manual - Module REC Alpha - IEC/IEC
Ref: PM-IM-
Rev: . US
-
Clearance Gap
. - . in
 -  mm
. - . in
 -  mm
>. in
> mm
Clamping Zone
Design Load
Test Load
Design Load
Test Load
Design Load
Test Load
Long Side
Mounting
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
Short Side
Mounting
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
SIX POINT MOUNTING: REC ALPHA PURER
A six-point mounting configuration secures the panel on three continuous rails (or other support structures) with three clamps on each side of the panel
in the zones marked below:
Six-point mounting configuration clamping zones: REC Alpha Pure-R Series
Rail positioning
NOTE
Once a module is secured in each of the  zones , additional clamps, i.e., ≥, may be freely located on panel frame without affecting the warranty.
Loads marked with a * were not certified as part of IEC / testing; these have been evaluated by REC’s internal testing process.
CAUTION
• The middle rail must not be installed on the side of the junction box where the cables exit.
• A total of three continuous rails (or other support structures) must be used to secure the panel.
• The center point of each clamp and the minimum grip length must be fully located within the marked zone to be rated to the given value.
1
2
43
GR
GR
GR
GR
GR
100 mm - 400 mm
GR
GR
GR
GR
GR
820 mm - 910 mm
400 mm - 100 mm
3.9 - 15.7 in 32.3 - 35.8 in
15.7 - 3.9 in
Fig. -