REC ALPHA PURE - Page 33

-
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
Rev: . US
REC Installation Manual - Module REC Alpha - IEC/IEC
Ref: PM-IM-
Rev: . US
-
INSTALLATION OF REC ALPHA PURERX SERIES PANELS
Clearance Gap
. - . in
 -  mm
. - . in
 -  mm
>. in
> mm
Clamping Zone
Design Load
Test Load
Design Load
Test Load
Design Load
Test Load
Long Side
Mounting
. - . in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
Short Side
Mounting
. - . in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
MOUNTING REC ALPHA PURERX SERIES PANELS WITH CONTINUOUS RAILS PARALLEL TO SHORT SIDE OF THE PANEL
A continuous rail (or other support structure) spans the complete underside of the panel
Clamping of REC Alpha Pure-RX Series panels with Rails parallel to the Short Side of the Panel
Rail positioning
Rail positioning
NOTE
Once a module is secured in each of the  zones , additional clamps, i.e., ≥, may be freely located on panel frame without affecting the warranty.
Loads marked with a * were not certified as part of IEC / testing; these have been evaluated by REC’s internal testing process.
CAUTION
The center point of each clamp and the minimum grip length must be fully located in the same clamping zones to be rated to that load. If the panel
is secured in zones with diff erent load values, it is rated to the lowest load value only.
1
2
43
290 mm
730 mm
410 mm
300 mm
200 mm
0
90 mm
0
300 mm
200 mm
0
300 mm
200 mm
0
300 mm
200 mm
0
520 mm
290 mm
730 mm
410 mm
0
90 mm
520 mm
570 mm
570 mm
730 mm
300 mm
200 mm
0
90 mm
0
300 mm
200 mm
0
300 mm
200 mm
0
300 mm
200 mm
0
730 mm
0
90 mm
Fig. -