-
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
Rev: . US
REC Installation Manual - Module REC Alpha - IEC/IEC
Ref: PM-IM-
Rev: . US
-
Six-point mounting configuration clamping zones: REC Alpha Pure-RX Series
Clearance Gap
. - . in
- mm
. - . in
- mm
>. in
> mm
Clamping Zone
Design Load
Test Load
Design Load
Test Load
Design Load
Test Load
Long Side
Mounting
. - . in
- mm
- -
+ Pa / - Pa
+ Pa / - Pa
Short Side
Mounting
. - . in
- mm
- -
+ Pa / - Pa
+ Pa / - Pa
Long Side
Mounting
. - . in
- mm
- -
+ Pa / - Pa
+ Pa / - Pa
Short Side
Mounting
. - . in
- mm
- -
+ Pa / - Pa
+ Pa / - Pa
MIXED SIXPOINT MOUNTING FOR SHORT RAILS: REC ALPHA PURERX
A mixed six-point mounting configuration secures the panel on three short rails (or other support structures) with three clamps on each side of the panel
in the zones marked below:
Mixed Six-Point Mounting of REC Alpha Pure-RX Series Panels using short rails
Min.
2
5 m
m
Max
.
Min.
1
00
mm
Max
.
200 mm
Rail length under module - mm
Rail length under module - mm
NOTE
Once a module is secured in each of the zones , additional clamps, i.e., ≥, may be freely located on panel frame without affecting the warranty.
Loads marked with a * were not certified as part of IEC / testing; these have been evaluated by REC’s internal testing process.
CAUTION
• The middle rail must not be installed on the side of the junction box where the cables exit.
• A total of three continuous rails (or other support structures) must be used to secure the panel.
• The center point of each clamp and the minimum grip length must be fully located within the marked zone to be rated to the given value.
GR
GR
GR
GR
GR
GR
GR
GR
GR
GR
840 mm - 890 mm
0 - 200 mm
0 - 200 mm
33.1 in. - 35.0 in.
0 - 7.9 in.
0 - 7.9 in.
Fig. -
To Next Page
Loading...
