REC ALPHA PURE - Page 6

-
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
Rev: . US
REC Installation Manual - Module REC Alpha - IEC/IEC
Ref: PM-IM-
Rev: . US
-
PANEL HANDLING
In order to avoid damage, all REC solar panels should be handled with care and protected from damage at all times. All warnings and instruc-
tions on the packaging should be observed. Follow these guidelines when unpacking, transporting, carrying, installing or storing panels:
• Record the serial numbers prior to installation and note the information in the system documentation,
• Carry the panels using both hands and do not use the junction box or cables as a grip,
• Do not allow the panels to sag or bow under their own weight when being carried,
• Do not subject panels to loads or stresses, e.g., leaning on them or through the placing of weight on them,
• Do not stand or walk on the panels,
• Avoid dropping the panels as any damage caused may be unseen,
• Keep all electrical contacts clean and dry,
• Do not apply force to the backsheet,
• Avoid using sharp or pointed objects if panels require marking,
• Never apply paints, adhesives or detergents to the front or rear of the panel,
• Do not use any solar panel that is damaged or has been tampered with,
• Never attempt to disassemble, modify, or adapt the panels or labels in any way as this will void the warranty.
NOTE Use clean and protective gloves when handling the panel as this will avoid the transfer of any fingerprints or soiling
to the highly-sensitive and anti-reflective glass surface, ensuring improved light transmission and avoiding any
contamination.
CHOOSING AN INSTALLATION LOCATION
REC solar panels are designed to provide decades of durable and stable output in installations up to  ft ( m) above sea level.
Ambient operating temperatures must be between -° - °F (-° and +°C).
Near sources of flammable gas or vapor e.g., gas containers or spray paint facilities,
• Near open flames,
• Where the panelsare exposed to direct contact with salt water/spray,
• Under water or in water features,
• Where exposed to sulfur e.g., near sulfur springs or volcanoes,
• Where exposed to artificially concentrated sunlight,
• Where the panels may be exposed to harmful chemicals.
NOTE For information regarding installations on water platforms, e.g., floating pontoons, see Special Installations.