Record Power WG250 - WG250;G Short Knife Jig; Short Knife Jig Operation; Jig Components Identification

Original Instruction Manual | WG250 Wet Stone Sharpening System | Version 3.0 | November 201222
10.1. WG250/G Short Knife Jig
Getting to Know the Short Knife Jig
The adjustable clamp allows the jig to hold knives of
any thickness.
A. Adjustable Clamp
B. Adjustable Stop
C. Screw to adjust clamp to thickness of blade
D. Knob to lock the knife in place
E. Fine adjustment knob
Using the Short Knife Jig
1. Loosen the large knob (D) on the centre of the clamp.
2. Place the knife in the clamp.
3. Use the screw (C) to adjust the clamp to the thickness of
the knife.
4. Tighten the large knob (D) on the centre of the clamp to
lock the knife in place.
5. The correct knife position when held in the clamp will
keep the bevel and the edge angle consistent along the
length of the blade.
A
B
C D
45mm
A
B
C D
100mm
E
E
A
B
C D
45mm
A
B
C D
100mm
E
E
6. Rest the Adjustable Stop (B) of your jig on the
Sharpener’s
Support Arm.
7. The edge angle can be adjusted by turning the screw (E)
on the side of the Adjustable Stop (B).
8. An inclusive angle of 25-30º range gives a uniform grind
across the blade.
9. Ensure slow consistent movements over the grind stone.
10. Turn the jig holding the knife over to repeat process.
A
B
C D
45mm
A
B
C D
100mm
E
E
Use to sharpen:
• Knives up to 4” in length
• Pocket knives
• Small cutlery knives