What to do if my Red Fire Speaker System has distortion?
If you are experiencing distortion with your Red Fire Speaker System, and the Clip LED is illuminated, reduce the levels of the MIC channel, LINE channel, and/or MASTER. Also, verify that you have not connected a line-level signal to the MIC input.
What to do if Power LED is on but MASTER VOL is low on my Red Fire Speaker System?
If your Red Fire Speaker System has the Power LED on, but the MASTER VOL is low, raise the MASTER VOL level.
What to do if Power LED is on, MASTER VOL raised but input channel signal is low on my Red Fire 10?
If your Red Fire Speaker System's Power LED is on, the MASTER VOL is raised, but the input channel signal is still low, check the connections between your audio sources and the inputs. Also, raise the channel LEVEL.
How to stop booming sound on Red Fire 10?
To address booming sound from your Red Fire Speaker System, cut the LOW level.
How to fix harsh sound on Red Fire Speaker System?
To fix harsh sound on your Red Fire Speaker System, cut the HIGH level.
Details various input connectors and control knobs for audio adjustment.
Describes power connection, fuse, and on/off switch for the device.
General| Power Output | 10W |
|---|---|
| Signal-to-Noise Ratio | ≥80dB |
| Bluetooth Version | 5.0 |
| Input Voltage | 5V |
| Bluetooth Range | 10 meters |
To Next Page