67
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to oper-
ate this equipment.
This equipment has been tested and found to comply with the limits of a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction may cause
harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures.
UÊ Reorient or relocate the receiving antenna
UÊ Increase the separation between the equipment and the receiver
UÊ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
UÊ Consult the dealer or an experienced radio/TV technician for help
Caution: To maintain the compliance with the FCC’s RF exposure guideline, place Media Connector & TOPCAT at least 20 cm from nearby persons.
To Next Page
Loading...