6) Move choke lever to full on position (left)
7) Move engine stop switch to “run” (right).
8) Pull rear brake lever (left side) and engage parking brake.
9) Press and hold engine start button until engine starts.
a. NOTE: If engine does not start within five seconds, release start button to
prevent starter damage.
10) Upon engine start up, allow engine to idle for 15 minutes.
11) After 15 minutes, adjust idle with a slotted screwdriver to a low, consistent idle
(roughly 950 RPMs).
b. NOTE: Turning idle screw in (clockwise) will raise idle. Turning idle screw out
(counter-clockwise) will lower idle.
24
To Next Page
Loading...
