Redkite Sleeptight - Opening the Sleeptight Travel Cot; Safety Checks Before Use; Assembly Verification

To open
1. Pull back the Velcro straps, remove the mattress and
set aside.
Fig 1.
2. Lift the four top folding rails up until they click into
place. Do not push the centre hub down until all four
folding rail locks are fully locked and engaged. The rails
will be horizontal and rigid when this is done correctly.
Fig 2.
NOTE If the folding rails do not click into place easily,
check again that the centre hub is raised. Do not apply
excessive force.
3. When all four folding rails have clicked and locked into
place, spread the legs of the travel cot and then firmly
press the centre hub down. The safety lock in the
centre hub will then automatically engage.
Fig 3.
4. Place the mattress inside the travel cot with the
padded side up.
Fig 4.
5. Feed the Velcro straps on the bottom of the mattress
through the corresponding holes on the base of the
travel cot. Attach the straps to the other Velcro
fastening under the cot. This ensures your mattress
remains secured safely. You may need to lift the travel
cot slightly to do this.
Fig 5.
Safety
Ensure the travel cot is correctly assembled before
use, with the top bars locked straight, the centre foot
firmly on the ground and the mattress in position.
Do not, under any circumstances, use the travel cot
unless all folding rails are fully engaged.
Fig 1.
Fig 2.
Fig 3.
Fig 4.
Fig 5.
Velcro straps
Centre hub
Folding rail
Folding joint
with button
underneath
Open and unfold the
mattress
2. Push centre hub down
1. Spread legs of travel cot
Mattress
Velcro tab and strap (x4)
Central folding mechanism
Folding rail Folding rail
Under side of travel cot