Need help?Do you have a question about the RedNet Focusrite and is the answer not in the manual?
General| Input Impedance | 2.4kΩ |
|---|---|
| Form Factor | 1U Rackmount |
| Bit Depth | 24-bit |
| Phantom Power | Yes |
| Software | RedNet Control |
| A/D Resolution | 24-bit |
| Type | Audio Interface |
| Sample Rate | 192 kHz |
| Connectivity | Dante |
Specifies requirements for network switches like Gigabit Ethernet, non-blocking, and QoS for Dante audio.
Details required network cable types (Cat 5e/6) and length limitations for Dante connections.
Introduces Dante Virtual Soundcard as software enabling PC Ethernet ports for Dante audio, often included free.
Outlines computer needs for running RedNet and Dante software, supporting both Mac and Windows.
Lists three methods for computer audio transfer: RedNet PCIe, RedNet 5, and DVS.
Explains RedNet Control's role as a remote control and routing center for RedNet products.
Describes Dante Controller for flexible routing and control of Dante products, including third-party devices.
Explains operation modes (Redundant/Switched) and connection rules for Dante devices with dual network ports.
Illustrates a network diagram showing the setup for mixing redundant and non-redundant Dante devices.
Guides on selecting the correct network adapter within RedNet Control for Dante connectivity.
Advises on setting the Host Mode in RedNet Control for proper I/O routing to the host system.
Explains how to set the default sample rate and where to adjust individual unit sample rates.
Addresses Pro Tools channel limitations and how to configure RedNet PCIe for optimal performance.
Details the process and importance of keeping RedNet units and software firmware up-to-date.
Covers basic routing with RedNet Control and advanced routing options using Dante Controller.
Provides links to FAQs, support contacts, and troubleshooting advice for RedNet systems.
To Next Page