For more playing comfort you can now adjust the general sensitivity for the optical sensors inside the chanter.
B. Sensitivity of the chanter
This function allows you to change the point where the sensors consider the hole closed and open
Briefly press the match into the hole above the control light
The red LED flashes 1-5 times. 1 time is near, 5 times is further away from the tonehole
We prefer level 2
Factory set-up for the chanter
If you wish to return to the setup as it was when the redpipe was delivered to you – this is how it goes:
1. push the match into the hole above the LED. After five seconds first - the LED indicator light is lit
continuously
2. hold the match pressed - until after about 15 seconds the LED start to flash up.
Now your chanter is calibrated again with the Factoy set-up.
Do you want your future to your own settings, proceed as described in A.
If the calibration button is pressed too long (about 30 seconds) your own and the factory calibration will be erased,
the LED on the chanter will flash quickly and also the switching on of the Redpipe. The chanter does not work
anymore and needs to be recalibrated A. If you are then satisfied with the calibration, press the factory settings
again. Now your current calibration is taken over as factory setting.
Cleaning the sensor window
Dilute dishwashing liquid 1: 4 with water and clean the sensors from time to time with a soft cloth or
a Q-tip.
Videoclip calibrating chanter
english: https://vimeo.com/215353113 french: https://vimeo.com/215353981
To Next Page
Loading...