The connected MIDI devices are
not adjusted to receive on MIDI
channel 1 or volume too low
Check adjustment at the MIDI
device, check corresponding
owners manual
The internal microprocessor is in an
undefined state
See above
· Sensors respond delayed or not
at all
Dry skin Use hand cream to increase the
circuit capacity of the hand
· Wrong addressing of the
sensors at stage.
Ground potential is missing at the
amplifier
Some amplifiers generate
glitches. In such a case use
radio transmission, a DI Box, or
ground the amplifier.
· Sensors seem to ‘hang’, i.e.
after take the finger away
nothing happens
The chanter is moist or dirty Dry or clean the sensor area
carefully. If necessary use a bit
soap and water. (clean the
sensor area all around)
· Adjustments are lost after
switching off
The sound was not stopped before
switching off
Always stop the sound before
switching of the slide switch
To Next Page
Loading...