Power ON
Use the slide switch to switch on the redpipe. The green indicator LED lights up for 2 seconds and then starts blinking
continuously. If the redpipe has not been operated for a longer period there is a humming sound indicating the
activation of the pressure sensors. Then the redpipe is ready for playing. If the redpipe is switched on but not in use it
will move to a power-saving mode after approximately 2 hours. To restart the instrument switch it off and on again.
IMPORTANT: Even in the power-saving mode the redpipe consumes a little power. To lengthen the lifetime of the
batteries, use the slide switch to power off the chanter after using it.
green indicator (LED)
The upper green LED shows the operating status of redpipe. The following information is displayed:
Display green LED Function
off the redpipe is switched off or in power-save mode
one flash per second the redpipe is ready for playing
continuous light
(short interruption shows activity)
The chanter is active
The green LED blinks with the beat of the Metronome Metronome
Shut-off control elements
Block control buttons (to avoid unintentional change of settings)
ON - press the SOUND, MET and + and then switch on the redpipe
OFF - press the SOUND, MET and - and then switch on the redpipe
Change used batteries before a new public appearance!
To Next Page
Loading...