NOTE: IMPORTANT…NOT TO DO!
• Do not try to change output jacks (impedance) while the amplifier is on. You
must turn STANDBY and POWER switches to OFF position before changing the
output impedance.
• Do not try to change input/output levels of you devices plugged into fx loop
while the amplifier is on. You must turn STANDBY and POWER switches to OFF
position before changing input/output levels of your gear plugged into fx loop
or at least disconnect cables form SEND and RETURN jacks.
THIS OPERATIONS CAN LEAD TO FINAL BREAK OF THIS AMPLIFIER. IN THESE
PARTICULAR CASES RED SEVEN AMPLIFICATION WILL NO BE RESPONSIBLE FOR
DAMAGES TO AMPLIFIER ITSELF OR PEOPLE. PLEASE KEEP IN MIND YOU ARE
HANDLING A DEVICE WITH POTENTIALLY LETHAL VOLTAGE. PLEASE CAREFULLY
READ THIS MANUAL BEFORE TURING ON THE AMPLIFIER.
RED SEVEN AMPLIFICATION ARE NOT RESPONABLE FOR ANY PARTS SUBJECT TO
WEAR (LIKE TUBES, POTS, CAPACITORS, ETC).
WARNING!!
This amplifier uses potential lethal voltage, it must be inspected
only by expert people!
WARNING!!
Before insert power cord inside Duality100, check the voltage plate
under IEC socket and be sure to match wall voltage of your
country.
To Next Page
Loading...