FIRST USAGE
Before plugging in the power cord, make sure to check the input voltage of the
amplifier and be sure to match it with your wall voltage, and then insert the power
chord.Before plugging in the speaker cable, check the impedance of your cab and
match the output impedance of the amplifier with the impedance switch on the rear
panel, then connect the speaker cable from cabinet to amplifier.
Now you are ready to put the Power Switch in “POWER ON” position. Leave the amplifier
in this state for at least thirty seconds.Plug your signal cable into input jack then you
are ready to put the Standby Switch to “ON” position. Now you can rockʼnʼroll!
To Next Page