14
NOTE: The cables should cross inside the
fuselage as shown
when installed to
the servo horn.
•Next, place a piece of masking tape at the
rudder counter balance to lock the rudder in
the centered
position. The
power on the radio
to lock the rudder
servo centered.
•Install the ball links to the rudder horns and
tighten the cables. Make sure the cable loop at
the servo is pulled properly and the cable is
tight then crimp the rudder end of each cable.
From the Pro: If you make a mistake on the pull-pull
setup and ruin a cable, you can use 60lb-test fishing
leader line and crimps found at your local outdoor
sports retailer as a replacement.
To Next Page