MILLI PURE VERTICAL SINGLE HEATED
TOWEL RAIL 900X38 - CHROME
HARD WIRING
Hydrotherm recommends that all hard-wired heated towel rails be connected to a light switch
or timer.
Connecting hard-wired heated towel rails to a light switch or timer will prolong the life of the
electric element and reduce energy consumption.
Hydrotherm recommend the brand HPM and the model XLP770TRT, this particular unit is
designed specically for heated towel rails that is incorprated into a light switch panel.
At Hydrotherm we pride ourselves on the highest quality standards of design and
manufacturing.
All Hydrotherm products come with a 10 year manufactures warranty on the construction
and finish of our towel rails.
All electric heating elements are covered by a 3 year manufactures warranty.
100% Australian Made and Owned
Construction & Finish
Manufacturers Warranty
year
Electric Element
Manufacturers Warranty
7
3
year
CARE DETAILS
This bathroom product should not be cleaned with abrasive
materials eg. steel wool/scourers. Do not use any corrosive or
abrasive cleaning agents containing acids or scouring agents.
Bleaches can also discolour products and therefore should not
be used. Damage caused by any improper treatment is not
covered by the product warranty.
Disclaimer: Products in this specication manual must be installed by licensed and registered
trade people. The manufacturer/distributor reserves the right to vary specications or delete models from
their range without prior notication. Dimensions are nominal measurements only. Dimensions and set-outs
listed are correct at time of publication however the manufacturer/distributor takes no responsibility for
printing errors.
HYDROTHERM WARRANTY
TOWEL RAILS MUST ALWAYS BE INSTALLED WITH THE ELECTRIC ELEMENT
POSITIONED AT THE BOTTOM OF THE UNIT FOR CORRECT HEAT TRANSFER
page 5 of 5
Plumbers, please ensure a copy of the installation
instructions is left with the end user for future reference
To Previous Page
Loading...