Mizu Drift Heated Towel Rail
Polished Stainless Steel
Page 1 of 4
Installation Instructions
WARNING
This product must be installed by a qualified electrician in accordance with AS/NZS 3000 wiring rules. Switch off the electrical
supply at the mains before installation and maintenance. A means of disconnection must be incorporated in the fixed wiring
in accordance with the wiring rules. For complete temperature control a wall mounted dimmer switch (with “off” position) is
recommended. Suitable for bathroom and non-bathroom/dry areas. Not suitable for above baths, nor for installation in saunas,
steam rooms or shower cubicles. Please consult with a qualified electrician to confirm appropriate compliant installation
location.
Do not connect to a plug and socket outlet. Rated IP45 and suitable for indoor use only. Do not fix to damp or conductive
surfaces. Site well away from curtains and fabrics. Switch off after use.
This appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
WARNING: In order to avoid a hazard for very young children, this appliance should be installed so that the lowest heated rail
is at least 600mm above the floor.
For safety, please DO NOT use for any purpose other than as a towel rail and a towel warmer. To avoid damage DO NOT sit,
stand, lean or hang on product.
Electrician, please ensure a copy of the installation
instructions is left with the end user for future reference.
To Next Page
Need help?
General