5. Press ENTER key to confirm.
The radio initially sets to the ALL COUNTY CODES by
default. With this option, the radio will respond to all
alerts regardless of the affected areas as long as the
channel is correctly set.
If you want to monitor alerts in more than one county
(area), the MULTIPLE COUNTY option would be the
choice. You can store up to 26 county codes in the radio
memory. The more the county codes you store in, the
broader the area coverage the radio will monitor and
vice versa.
If the SINGLE COUNTY option is selected, the radio
will monitor alerts only affecting your local county /
area. You must store the county code in the first memory
location which is COUNTY 01.
If the ALL COUNTY CODES option is selected,
this section is completed.
If there is no county codes stored in the memory, go
to next step.
6. Press or key to scroll memory locations for county
code entry / edit.
7. Press ENTER key to select.
8. Press or key to input the desired code number.
9. Press key to the next digit.
10. Repeat steps 8 & 9 to input the 2nd to 6th digit.
11. Press ENTER key to save.
Press and hold or key will continuously
change the number. Release the key to stop.
Repeat steps 6 to 10 to enter the next county code, if any.
If any one of the code digit is blank ( _ ), the input
will not be updated.
If there is no county codes stored in the memory, the
radio will re-set to ALL COUNTY CODES option
automatically.
Press PROG key to leave this section.
Info
Hint
Hint
Tips
Hint
Note
Setting Alert Mode
Alert Option Table:
You Hear:
Alert Option:
ALARM OUT
Socket:
You See:
Alert
Enable
VOICE
Alert Disable
8 seconds siren, then,
voice broadcast the
message (maximum
15 minutes) or until
you press STOP key.
Activates for
8 seconds
LCD
displays
event alert
message
and
Effective
Time.
5 minutes siren or
until you press
STOP key.
No siren and
voice broadcast
Activates for 5
minutes or until
you press
STOP key.
SIREN
Not
activate
At the VOICE option, after voice broadcast, the radio
will return to the previous state.
The Alert Option Table below describes how the radio will
respond in both visual and audio upon receiving alerts. .
Alert Enable and VOICE options are preset by default.
If you are satisfied with this setting, skip this section.
1. Press and hold PROG key for 2 seconds to enter program
menu page. Skip this step if it is now in program menu.
2. Keep pressing key to the menu page P4.
3. Press ENTER key to select.
4. Press key to select the alert option either Alert Enable
or Alert Disable..
6. Press key to select either VOICE or SIREN option.
7. Press ENTER key to confirm and complete this section.
If Alert Disable is selected, this section is completed.
Press PROG key will leave this section without update.
5. Press ENTER key to confirm.
Info
Hint
Note
Hint
- 3 -
To Next Page
Loading...