Setting Event Blocking (defeat siren / voice)
1. Press and hold PROG key for 2 seconds to enter program
menu page. Skip this step if it is now in program menu.
2. Keep pressing key to menu page P6.
3. Press ENTER key to select.
4. Press key to scroll through the alert messages to edit.
7. Press ENTER key to confirm.
8. Repeat steps 4 to 7 to edit others if you desire.
Alert Disable (flashing) = Event Blocked
Alert Enable (flashing) = Event Not Blocked
5. Press ENTER key to select the message to be edited.
6. Press key to set it to block or not.
The Event No., Corresponding to the Alert Message
Table, is displayed on the LCD.
Some alert messages can be set to no audio alert (SIREN
and VOICE) but display the messages on the LCD in
order not to annoy you frequently.
These messages are grouped from Event No. 1 to 48 in
the Alert Message Table. When the radio receives such a
message e.g. REQUIRED WEEKLY TEST, and you have
already set it blocked, there will be no siren nor voice
alert but display the message on the LCD.
The ALARM OUT socket will not be activated if the
blocked event is received.
The messages below are initially set to block
at the factory (by default).
1. REQUIRED WEEKLY TEST
2. REQUIRED MONTHLY TEST
3. ADMINISTRATIVE MESSAGE
4. NATIONAL INFORMATION CENTER
5. NATIONAL PERIODIC TEST
6. NATIONAL AUDIBLE TEST
7. NATIONAL SILENT TEST
8. NETWORK NOTIFICATION MESSAGE
9. PRACTICE / DEMO
Editing Event Blocking
Press PROG key to end this section.
Info
Note
Hint
Note
Hint
- 6 -
1. The audio alert tone can be tested in menu
page P8, SIREN TEST.
2. The alert messages from Event No. 1 to 48 in the
Alert / Test Message Table can be individually set to
block or unblock. See next section for details.
3. The alert messages from Event No. 49 to 76 in the
Alert / Test Message Table are always preset to
unblock at the factory (by default). Defeat siren
options for these alert messages are not available
in Editing Event Blocking section.
No.
Audio Alert Tone
Non-Alert Messages
1. TRANSMITTER BACKUP ON
2. TRANSMITTER CARRIER OFF
3. TRANSMITTER CARRIER ON
4. TRANSMITTER PRIMARY ON
None
When the radio receiving Non-Alert Messages
described in the table below, it will not generate
audio tone nor display the message on the LCD but
the message will be saved to the event memory. A
new received message will over-write the Non-Alert
message in the event memory.
Non - Alert Message Table
Event
No.
Audio Alert Tone
Alert Message on Display
73. TSUNAMI WARNING
74. VOLCANO WARNING
75. WILD FIRE WARNING
76. UNRECOGNIZED WARNING
Warning Siren
Warning Siren
Warning Siren
Warning Siren
Alert Message Table (continue)
Note
Note
69. SHELTER IN-PLACE WARNING
70. TORNADO WARNING
71. TROPICAL STORM WARNING
72. TSUNAMI WATCH
Warning Siren
Warning Siren
Watch Siren
Warning Siren
Non - Alert Messages
To Next Page
Loading...