Reed Instruments R6020 - Page 7

7
LEDs Status Indication Action
REC ALM
Both LED
lights OFF
Logging not active Start logging
Low battery or no
battery installed
Install or replace
battery
REC ALM
Single Green
ash every
10 seconds*
Logging, no set
alarm triggered**
No action required
Double Green
ash every
10 seconds*
Manual start was
chosen from setup
Press and hold the
start button until the
Green and Yellow
LEDs ash indicating
recording has started
REC ALM
Single Red
ash every
10 seconds*
Logging, Low
alarm for relative
humidity triggered
No action required
Double Red
ash every
10 seconds*
Logging, High
alarm for relative
humidity triggered
No action required
Single Red
ash every 60
seconds
Low Battery Replace Battery,
download saved
data
REC ALM
Single Yellow
ash every 10
seconds*
Logging, Low alarm
for temperature
triggered
No action required
Double Yellow
ash every
10 seconds*
Logging, High alarm
for temperature
triggered
No action required
Single Yellow
ash every
60 seconds*
Memory full Download data
*To conserve battery power, the LED ashing frequency can be adjusted between 15 and 30
seconds in the software.
**To conserve battery power, the alarm LEDs for temperature and humidity can be disabled
via software.
1.800.561.8187 info@REED-Direct.ca
REED-Direct.ca