REED R5600 - Low Resistance Measurements; AC;DC Voltage Measurements; Lock Power On Feature

reedinstruments
www
com
8
Pantone 534 Blue
Pantone 123 Yellow
Pantone 485 Red
Pantone 123 Yellow
Pantone 534 Blue
Black
Rich Black -
20/20/20/100
Blue - 100/80/30/5
Yellow - 0/27/100/0
Red - 10/100/100/5
Yellow - 0/27/100/0
Blue - 100/80/30/5
Only if you REALLY need them:
Pantone 534 Blue - 100/80/30/5
Pantone 485 Red - 10/100/100/5
Pantone 123 Yellow - 0/27/100/
INSTRUMENTS
Note: Makesurethatthecircuitunderdoesnotincludecomponents
Whichwillbedamagedbythe1000Vapplied.Manynormalcomponents
ofaninstallationarelikelytobedamagediftestedat1000V.Examplesare
powerfactorcorrectioncapacitors,lowvoltagemineralinsulatedcables,
electroniclightdimmers,electronicballastsandstartersforuorescent
lampsetc…
Lock Power on Feature
Forhandsfreeoperationalockpoweronfeatureisincorporatedinthe
presstotestbutton.SettheLOCKbuttontolocktestvoltage,pressingit
again will turn the tester off.
Low Resistance (Continuity) Measurements
1.Settherangeswitchto200Ω•)))Position
2.ConnecttheredtestleadtotheVΩterminalandbacktothe
COMterminal.
3.Connectthetipsofthetestleadstobothendsofthecircuitundertest.
ReadresistanceinΩontheLCD.
4.Whentheimpedanceoncircuitisbelowapproximately40Ω.
Itwillindicatebyacontinuousbeeper.
AC/DC Voltage Measurements
1.SettherangeswitchtoACVorDCVposition
2.Connectredtestleadto“VΩ”terminalandblacktestlead
toterminal“COM”.
3.ConnecttestprodsoftestleadsINPARALLELtothecircuit
beingmeasured.
4.ReadthevoltagevalueonLCD.
w ww . . co m
information@itm.com1.800.561.8187