If the machine is used non-stop (and this is NOT recommended) over a long period you may create a situation
whereby the concentration of smoke is too much, which can result in build-up of residue in the environment. You may
also experience some residue after a long period of using the machine as recommended and this can be seen on
equipment close by, especially those with air filters and fans etc. However, normal periodic cleaning of this equipment
will prevent this. If the machine is to be used continuously, then a timer should be used to create a 10-second off
period to allow the water trap to automatically drain.
OPERATING
Always
1. Transport the unit right side up or empty.
2. Before operating, fill with Diffusion Fog Fluid just below the top of the tank window on the side of the unit. ALWAYS
TAKE CARE NOT TO OVERFILL.
3. Check the machine for correct voltage.
4. Check the female plug for tight connection before plugging the male end into an AC voltage
receptacle. New line DC
voltage will result in damage to the machine.
5. If the circuit breaker trips, then turn OFF the machine and reset by depressing the breaker
button, then turn back ON. Be
sure to plug directly into a wall outlet or use a 2.5mm
2
extension cord. Note: When starting the
voltage must not drop
less than 80% of nameplate voltage. If it continues to trip contact your dealer.
6. The machine must be level to operate properly.
7. The machine holds 2 liter’s or 1/2 gallon of fluid. DO NOT OVERFILL. If you overfill, then it may
be necessary to remove
thecover to clean up the excess fluid.
FILLING INSTRUCTIONS
1. Unscrew the cap on the top of the unit and pour fluid into the opening. Be careful not to overfill.
2. Do not use more than 2 liter’s or 1/2 gallon of fluid.
3. Check the level by using the sight window on the side of the unit.
To Next Page
Loading...