Reencle Prime - Frequently Asked Questions; Product Condition and Away-from-Home Care

Reencle MANUAL 17
Q. There is condensation on the inner surface of the cover and on the inner sides
of the product.
Q. Mold has grown on the inner walls and over microorganism.
Q. Microbes have accumulated and set on the corners and walls of the tank.
Q. If I am away from home for days, do I need to take any special measures?
VI. Frequently Asked Questions
A.
A.
A.
A.
The internal temperature of the product is set to be maintained at 50 to 60 degrees Celsius,
which is suitable for culturing microorganism. When 1.5L(50oz) of water is initially added or
in the course of general food decomposition, condensation may occur on the cover and the
inner walls due to the di󽗿erence between the internal and external temperature.
Condensation is a natural phenomenon and cannot be considered as a problem.
Mold is often found over microorganism, inner sidewalls, and the stirring rods, but has
nothing to do with microorganism. Use the shovel provided with the product to scoop it to
mix with the mixture inside and the mold will disappear after a few hours, as they are
decomposed with the mixture. Keeping the interior walls clean will help prevent mold.
The stirring rod rotates near the center of the product. Although it mixes most
microorganism, by-product may collect in the corners, so the microorganism accumulates
and set on the corners and walls. Use a shovel to scrape these microbes and mix them with
the mixture before adding food.
If you are away from home for more than 7 days, please refrain from putting food in from
2days before departure and completely decompose the remaining decomposition products
before leaving. On the day of departure, turn o󽗿 the product and unplug the power cord.
If you are away from home for less than 7 days, use Reencle as you normally would.
On the day of departure, make sure that the microorganism is not dry.
When activating the microorganism(food cleaner), pour the powder into the tank, add
500ml(16.9 oz) of water and leave it for 4-6 hours before starting use.