Reer FeelWell User Manual

- 12 -
230 V
1 2
Putting into operation
1. Insert the mains plug into the power socket (fig. 1).
2.
Pul
l the pull cord (fig. 2) to switch the heater on. The heater has two heat settings: 400 W (level „1“) and 800 W
(level „2“).
3
Pul
l the cord again to change the heat setting or switch the unit off (level „0“).
1.
T
o activate the automatic switch-off function, switch the timer switch on the
bottom of the unit to the „ON“ position. The unit switches off automatically
after 10 minutes.
2.
Ther
e are 2 ways of switching the unit on after automatic switch-off:
• Mo
ve the rocker switch to the „Off“ position or
• pul
l the pull cord, until the heat setting indicator shows „0“. If the pull
c
ord is pulled again on heat setting „1“ or „2“, the unit is switched on
again.
If the angle exceeds 25° (for example if the unit is mounted on the ceiling), the power supply to the unit is cut. The unit
switches back on automatically, when it is upright again.
Automatic switch-off function
Switch-off if tilted
Troubleshooting
I
O
TIMER ON
I
O
TIMER OFF
TIMER ON/OFF
I
O
10
I
O
TIMER ON
I
O
TIMER OFF
TIMER ON/OFF
I
O
10
TIMER ON/OFF
GB
English
issue possible causes remedial action
No heat radi-
ation despite
heat setting
indicator
showing „1“
or „2“.
• The power plug is not connected properly.
• The automatic switch-off function (timer)
is activated.
• The automatic tilt switch-off function is
activated, because the angle of the heater
exceeds 25°.
• Check the power plug.
• Turn the „Timer“ to „Off“ or switch the unit
off and then on again by repeatedly pulling
the pull cord.
• Ensure that the heater is level and fixed to
the wall.
1
0
2
ON
400 W
ON
800 W
OFF

Reer FeelWell Specifications

General

Brand	Reer
Model	FeelWell
Category	Heater
Language	English