WARNING
PAGE 1 3532700_RevA • Questions? (800) 234-6992 • ReeseBrands.comPAGE 1
These instructions contain IMPORTANT safety information. Please read and keep for future reference.
ENGLISH
INSTRUCTION GUIDE FOR:
7454000 Steel Center Fold Ramp
9515200 Steel Center Fold Ramp
Date of Purchase: / /
• Read, understand, follow and save all instructions before attaching and/or using product. NEVER allow anyone unfamiliar with these
instructions to use this product.
• Read, understand, follow and save all instructions provided by the manufacturer of the product(s) that this ramp will be used with.
• Failure to follow these warnings and instructions may result in property damage, serious bodily injury, and/or death.
• Extreme caution should be used when loading or unloading your equipment.
• Do not exceed the rated capacity of the ramp.
• Do not exceed the capacity of your loading surface (i.e. tailgate, bumper). If unknown, consult the manufacturer to find load
capacities.
• Do not drive or ride any equipment up or down the loading ramp.
• Straps must be secured tightly to limit any movement of the ramp while loading or unloading. If loading or unloading from a vehicle/
trailer, be sure the vehicle is parked with emergency brake engaged and/or wheels are chocked and engine is off. If loading or
unloading from a trailer, also make sure the trailer is properly coupled to the tow vehicle.
• Never stand in the path of equipment when loading/unloading with the ramp, and keep bystanders away from the ramps.
• This ramp must be used on a level and stable surface.
• Ramp surfaces may be slippery when wet or dirty.
• Ramps are intended for loading/unloading equipment onto a trailer or pickup truck. Do not use ramp sections as a ladder, bridge,
scaffolding, or for any other use.
• Keep body parts completely clear of the hinge pin area at all times.
• Do not attempt to load or unload power equipment with its engine running.
• Do not leave ramps unattended when attached. Someone not knowing the intended use may misuse the ramps or move the ramps
which may cause misalignment when returning to load/unload equipment.
• Do not cut, drill, weld or modify ramp sections. Any modifications to the ramp sections may cause them to become unstable. Never
use ramp if there are any broken, bent or worn parts.
• Ramp may scratch loading surface (i.e. tailgate, bumper, trailer, ground surface).
• Remove ramp from loading position before moving vehicle or trailer.
Review all Warnings, Instructions, and Warranty information carefully.
Failure to follow these warnings and instructions will void the Warranty.
For assistance with this product, please contact:
Horizon Global
47912 Halyard Drive Suite 100 • Plymouth, MI 48170
(800) 234-6992
Or visit www.ReeseBrands.com
To Next Page
Need help?
General
