Need help?Do you have a question about the Reflex Reflexomat RS 150/1 and is the answer not in the manual?
General| Brand | Reflex |
|---|---|
| Model | Reflexomat RS 150/1 |
| Category | Control Unit |
| Language | English |
Defines the device as a pressure maintaining station for heating/cooling water systems with specific water type requirements.
Explains the operational principles of the Reflexomat, including pressure maintenance and water make-up.
Covers connections to the facility system and external compressed air, with safety precautions.
Describes the exemplary water-side connection of the control unit to primary and secondary tanks.
Details the connection of the control unit to the primary tank, including compressed air and cable connections.
Provides instructions and standard values for installing the 'LIS' level sensor on the primary tank.
Provides safety warnings and general steps for making the electrical connection to the device.
Explains how to determine the minimum operating pressure (Po) and its calculation for controller setup.
Guides the user through the controller's start routine for initial parameter setup during commissioning.
Explains how to start the Automatic mode as the conclusion of the initial commissioning process.
Details the Automatic mode for continuous operation, including pressure maintenance and make-up functions.
Details how to adjust system-specific values using the Customer, Default, and Service menus for optimal operation.
Outlines the customer menu structure and available settings for system-specific value adjustment.
Explains how messages are displayed, their causes, and how to acknowledge or reset them.
Provides detailed steps for checking the cut-in/cut-out pressures and make-up activation points.
Provides safety warnings and procedures for safely disassembling the device, covering electrical and pressure risks.
To Next Page
