Rega Bias 2 User Manual

Bias
2
Red
Green
White
Blue
+
_
Packing
Rega have not tried to create a
false impression of expense by
using an elaborate package. We
have used the most simple and
cheap carton possible to avoid
transit damage, thereby using the
saving to spend more on the
cartridge itself - ensuring better
value.
Remove the location tags on
the stylus guard for use on in-
situ cartridge.
L
R
1) Play at 1.75 grams tracking
weight.
2) Tighten fixing screws securely
to clamp cartidge as tightly as
possible to the headshell.
3) Follow the turntable or arm
manufacturer’s instructions for
fitting the cartridge.
Innovation
Recent developments in coil
winding techniques have allowed
us to use our innovative parrallel
wound coil in our entire range.
This technique uses
approximately one third less wire
than our previous models, thus
producing a more efficient and
reduced mass cartridge.
Rear Cartridge View
Bias 2.qxd 18/11/2004 12:42 Page 1

Rega Bias 2 Specifications

General

Type	Moving Magnet
Output Voltage	6.8 - 7.2 mV
Tracking Pressure	1.75 g
Load Impedance	47kΩ
Load Capacitance	100 - 200 pF
Stylus	Elliptical
Frequency Response	20 Hz - 20 kHz
Channel Separation	20dB
Weight	5g
Mounting	Standard 1/2 inch
Tracking Force	1.75 - 2.00g

Summary

Cartridge Fitting Instructions

Tracking Weight and Securing

Set tracking weight to 1.75 grams and securely tighten fixing screws to the headshell.

Manufacturer's Guidelines

Follow the turntable or arm manufacturer's instructions for fitting the cartridge.

Innovation in Coil Winding

Parallel Wound Coil Technology

Uses an innovative parallel wound coil, reducing wire usage by one third for efficiency.

Product Packing Strategy

Simple and Cost-Effective Packaging

Employs a simple carton to avoid transit damage, prioritizing cartridge value over elaborate packaging.

Stylus Guard Tag Removal

Preparation for Use

Remove location tags from the stylus guard for in-situ cartridge use.