10
Service
To keep your P7 working perfectly, please ensure that your turntable is
returned to a Rega trained dealer for servicing at the recommended interval
periods (2000 hours playing time).
Transporting your P7
Should you need to transport your P7, to avoid any possible transit damage,
the following recommendations must be followed.
1. Remove tonearm balance weight and secure the arm in its rest with tape
or covered wire. This will ensure no sudden or violent movement is
transmitted to the delicate bearings.
2. Remove ceramic platter. When removing, hold down the metal hub at the
same time as lifting the platter on each side. When removing or replacing,
ensure it is done evenly to avoid chipping to the platter.
3. NEVER place your P7 upside-down or on its side. This would allow oil in
the hub/bearing assembly to leak and cause speed and or wear problems.
4. If you have to ship your turntable or use a carrier, use ALL the original
packaging. If in doubt ask your dealer.
Caring for your P7:
To Next Page
Loading...
