3
Bi-Wiring and Bi-Amping
The drive units in the R7 have been designed with
great care. The crossover needs no additional
filter networks to compensate for drive unit
problems. Unlike most manufacturers who boast
about the complexity of their crossovers, Rega are
proud of the simplicity of theirs. This simplicity
means that bi-wiring will offer no advantage, and
will often give worse results at an additional cost.
Bi-amping will improve the performance of both
mid/bass driver and tweeter units.
For normal use simply use either pair of +/-
terminals to drive the tweeter and bass/midrange.
For bi-amping, remove the bridging connectors,
and use the left HF +/- terminals to connect to the
high frequency tweeter, and the right LF +/-
terminals to connect to the low frequency
bass/midrange driver.
To Next Page
Loading...
