Need help?Do you have a question about the Rega RP10 and is the answer not in the manual?
General| Drive System | Belt drive |
|---|---|
| Tonearm | RB2000 |
| Speed | 33 1/3 RPM, 45 RPM |
| Type | Belt Drive |
| Motor | 24V Low Noise |
| Cartridge | Not included |
| Wow and Flutter | <0.10% |
| Dimensions | 360mm |
Discusses Rega's product development philosophy and its application to turntable design.
Details Rega's lightweight, stiff plinth structure using phenolic skins and foam core.
Explains the dual brace technology using magnesium and phenolic for reduced resonance.
Describes the custom ceramic flywheel platter, its construction, and improvements.
Details the high-specification 24V twin phase synchronous motor and its control.
Explains the design of the outer frame and its interaction with the inner plinth for dust cover use.
Describes the DSP-based power supply for speed control and waveform generation.
Details the RB2000 tonearm's features, construction, and performance enhancements.
Describes the bespoke, low-capacitance phono cable and its advanced plug design.
Provides instructions for setting tracking force and bias adjustment for the RB2000 tonearm.
Guides on placing the turntable on a sound and level surface for optimal performance.
Details how to connect the RP10 power supply to the turntable and mains.
Explains how to select 33rpm or 45rpm playback speeds using the front panel controls.
Guides on connecting the turntable to an amplifier's phono stage.
Overviews the front panel controls of the RP10 power supply unit.
Details the input and output connections on the rear of the power supply.
Provides advice on cleaning, operation, and general maintenance of the turntable.
Offers recommendations to prevent damage during transit, including platter and arm securing.
To Next Page
