Do's and Don'ts
Do not unplug the power supply from the turntable whilst the unit is on -
turn off the power supply before unplugging anything.
Do not operate the power supply without the turntable connected.
As you would expect there is a 24V AC plus a 20V DC signal present on
the pins of the plug - if these are shorted it will cause damage to the power
unit.
Do not connect both the P5/7 up-grade power supply box and the Rega
PSU1 power supply to the turntable - this will damage the P5 PSU unit.
To Next Page
Loading...
