212
Chapter 7
To change a hanging locker light bulb follow these steps:
Remove the lens cover from the lamp base. There is
a tab on the bottom of the lens cover. Push the lens cover
at this point to remove it.
Remove the defective bulb.
Replace the bulb with a 12 volt halogen bulb type
# 563.
Reinstall the lens cover by snapping it in place.
HANGING LOCKER LIGHTS-TYPICAL
READING LIGHTS-TYPICAL
Lens Cover Removed
Notched Area Here
Under Cover
The reading lights use a marine type bulb that allows for
rough service. To change the bulb turn the xture and
grasp the old bulb and pull it straight out. Replace with
the same wattage bulb. Reinstall the bulb in the lamp
socket using a tissue to hold it. This procedure will help
extend the bulb service life.
To Next Page
