Why does water continue dripping into the bowl after flushing my Regal 26 XO toilet?
If the water continues dripping briefly into the bowl after the flush cycle is complete on your Regal Boat, it is normal operation if only a small amount drips from the nozzle when the toilet is installed below water line with vacuum breaker in water supply line.
What to do if the main ELCI keeps tripping on my Regal Boat?
If your Regal Boat's main ELCI breaker is tripping frequently, it could be due to a component drawing excessive power. Try to identify and repair or replace the part that's causing the issue. After resolving the problem, reset the ELCI breaker.
Why are the AC outlets not working on my Regal 26 XO?
If your Regal Boat's AC outlets or equipment have no power, first check if the main AC ship's panel breakers have tripped or are in the “off” position; reset or activate them. Also, ensure the shore power cord is properly connected. Lastly, check for a tripped GFCI, find the cause, and reset it.
What to do if there is inadequate AC power with gen-set running on my Regal 26 XO Boat?
If there is inadequate AC power with gen-set running on your Regal Boat, turn off appropriate equipment breakers to lessen load.
How do I fix horizontal bars flickering on my Regal Boat TV?
If horizontal bars appear to flicker, jitter, or shimmer on the image of your Regal Boat's TV, adjust the fine function to the owner's manual specifications.
Why is the wall switch light not working on my Regal 26 XO toilet?
If the wall switch does not appear to light up or does not stay lit on your Regal Boat, check that breaker is not tripped and check electrical connectors are mated. Ensure wall switch electrical connector is fully engaged at controller. No action needed if wall switch has entered sleep mode.
What to do if my Regal 26 XO is not running on DC?
If the Regal Boat is not running on DC, replace the thermostat, converter or battery.
What to check if my Regal 26 XO is not running on AC?
If the Regal Boat is not running on AC, make sure proper voltage exists on ship’s main AC panel.
Why is my Regal 26 XO toilet inoperative with no light on the wall switch?
If the toilet is inoperative and there is no lighting in the wall switch on your Regal Boat, check that breaker is not tripped. Ensure all electrical connectors are mated.
What causes excessive vibration on my Regal 26 XO?
If there is excessive vibration on your Regal Boat, check for any material obstructing the propeller and remove it by reversing the engines. If there is no obstruction, the propeller shaft may be bent and requires authorized dealer. Also, the propeller blade may be bent and requires repair or replacement. Finally, the drive bearing may be noisy and requires drive unit repair or the drive casting may be damaged and requires replacement.
To Next Page
General
