Why does water continue dripping into the bowl after flushing my Regal Boat toilet?
If the water continues dripping briefly into the bowl after the flush cycle is complete on your Regal Boat, it is normal operation if only a small amount drips from the nozzle when the toilet is installed below water line with vacuum breaker in water supply line.
What to do if the main ELCI keeps tripping on my Regal Boat?
If your Regal Boat's main ELCI breaker is tripping frequently, it could be due to a component drawing excessive power. Try to identify and repair or replace the part that's causing the issue. After resolving the problem, reset the ELCI breaker.
Why are the AC outlets not working on my Regal 26 EXPRESS Boat?
If your Regal Boat's AC outlets or equipment have no power, first check if the main AC ship's panel breakers have tripped or are in the “off” position; reset or activate them. Also, ensure the shore power cord is properly connected. Lastly, check for a tripped GFCI, find the cause, and reset it.
How to troubleshoot a loss of DC power on my Regal 26 EXPRESS Boat?
If your Regal Boat has no DC (12 volt) power, make sure the battery switch is in the “on” position. If it is, the battery may be weak or dead, and you should charge or replace it.
How do I fix horizontal bars flickering on my Regal 26 EXPRESS Boat TV?
If horizontal bars appear to flicker, jitter, or shimmer on the image of your Regal Boat's TV, adjust the fine function to the owner's manual specifications.
What to do if my Regal 26 EXPRESS Boat is not running on DC?
If the Regal Boat is not running on DC, replace the thermostat, converter or battery.
What to check if my Regal Boat is not running on AC?
If the Regal Boat is not running on AC, make sure proper voltage exists on ship’s main AC panel.
What causes poor performance on my Regal 26 EXPRESS?
If you're experiencing poor performance with your Regal Boat, start by adjusting the trim. If that doesn't resolve the issue, check for an unbalanced load and adjust it accordingly.
What causes excessive vibration on my Regal 26 EXPRESS Boat?
If there is excessive vibration on your Regal Boat, check for any material obstructing the propeller and remove it by reversing the engines. If there is no obstruction, the propeller shaft may be bent and requires authorized dealer. Also, the propeller blade may be bent and requires repair or replacement. Finally, the drive bearing may be noisy and requires drive unit repair or the drive casting may be damaged and requires replacement.
Why won't the battery hold a charge on my Regal 26 EXPRESS?
If the battery on your Regal Boat will not hold a charge, it's likely that the battery is faulty or old. Replace the battery, ensuring you use an exact replacement.
Welcomes new owners to the Regal family and outlines the brand's commitment to excellence.
Explains the purpose of the owner's manual and the location of the information packet.
Details the terms, conditions, and coverage of the Regal limited warranty.
Defines safety labels and precautions, emphasizing the skipper's responsibility for safety.
Outlines essential safety equipment required on board, including PFDs and fire extinguishers.
Details fire extinguisher classification, types, features, and minimum requirements for vessels.
Explains navigation rules for avoiding collisions, including right-of-way and signaling.
Discusses the hazards of carbon monoxide, its sources, symptoms, and prevention measures.
Covers federal laws regarding operating a vessel under the influence and debunks alcohol myths.
Defines navigation rules and their application in inland and international waters.
Explains right-of-way rules for various vessel crossing, meeting, and overtaking situations.
Describes the purpose and types of navigational aids like buoys and markers.
Covers the use of navigation lights for safe operation during darkness or reduced visibility.
Details the typical gasoline fuel system, components, and gasoline specifications.
Introduces DC and AC electrical systems, components, and safety warnings.
Explains battery types, specifications, terminology, and maintenance procedures.
Covers alternating current (AC) general information, basic electrical terms, and load management.
Details the ELCI system for ground fault protection and leakage fault detection.
Describes the A/C system, components, operation, and inspection tips.
Explains the fresh water system, tank filling, and operational procedures.
Covers the chemical toilet system, waste water system, and macerator operation.
Details the operation of the windlass for paying out and retrieving the anchor.
Explains the operation and features of the typical chart plotter system.
Introduces the stern drive propulsion system, engine, and drive components.
Describes the instruments and gauges at the helm station for monitoring boat systems.
Covers starting engine procedures, ignition switch operation, and safety warnings.
Details outboard engine operation, controls, and fuel octane recommendations.
Explains the operation of the typical digital outboard remote control for shifting and trim.
Covers pre-departure checks and procedures for getting underway.
Details procedures for safe fueling, including before, during, and after fueling steps.
Provides guidelines for starting and stopping engines, including safety warnings.
Explains the anchoring process, scope determination, and securing the anchor line.
Covers emergency procedures for fire situations and basic first aid, including CPR.
Details trailer basics, before towing checks, driving with a trailer, and pre-departure checks.
Provides instructions and safety precautions for launching and loading the boat.
Introduces auxiliary equipment components and where to find detailed information.
Explains carbon monoxide detectors, how they work, and their operation.
Details the operation of automatic and manual fire suppression systems.
Describes the bow thruster system, safety notices, and operation.
Covers general care of the boat, including cleaning methods and safety information.
Provides guidance on routine maintenance, cleaning, waxing, and minor repairs for fiberglass.
Details the importance of battery maintenance, terminal cleaning, and electrolyte checks.
Outlines maintenance procedures for the air conditioning system, including cleaning and checks.
Introduces diagnostic charts for identifying minor problems in various boat systems.
Provides a chart for troubleshooting AC electrical problems, causes, and fixes.
Offers a chart for troubleshooting DC electrical issues, including power loss and battery problems.
Lists common fresh water system problems, their causes, and possible solutions.
Outlines storage procedures and the importance of proper winterization for boat equipment.
Provides a checklist for decommissioning the boat, covering hull, engines, and systems.
Details winterization methods for air conditioning, fuel tanks, and batteries.
Provides a list of nautical terms and their definitions for everyday boating.
An alphabetical index to help locate specific topics and information within the manual.
Provides general information on product specifications, changes, and dealer contact.
Introduces technical drawings of the boat's systems and components for troubleshooting.
Shows the general layout and arrangement of the 26 Express model.
Illustrates the various features located on the deck of the 26 Express model.
Provides approximate overall dimensions and critical measurements of the 26 Express.
Indicates the seating capacity and allowance per person for the 26 Express model.
Illustrates the vertical and horizontal fields of visibility from various seating positions.
Details the wiring and circuitry for the typical switch panel harness plugs.
Shows the layout and breaker descriptions for the domestic 120V AC main panel.
To Next Page
General
